פניאומטיים:the material cylinder and the cylinder are connected to the main body of the dispensing valve is made up of three parts: cylinder, valve body and material cylinder. The air cylinder and valve body are separated by advanced sealing material to prevent glue from invading the cylinder. The pneumatic body is used for the movement of the solenoid valve to drive the center rod up and down, and the up and down movement of the center rod is used to open and close the glue According to the different ways of opening and closing, it can be divided into: plunger-type valve, ejector-type valve, lifting-type valve, spray-dispensing valve, and jet-dispensing valve is the highest accuracy; the switching mode is Different, and the applicable fluid is also On the other hand, the suction-suction valve adopts an upward movement and closes the glue structure,so that the glue is sucked and broken at the same time and the residual glue on the remaining needle is reduced, so that the dispensing does not produce the phenomenon of leaking or drawing. הגוף שסתום הוא אנודייז ידי סגסוגת אלומיניום. The sealing material adopts The latest PTFE material. The contact colloid part is corrosion-resistant material.

Electric: mainly divided into a gear pump and a peristaltic pump including the pump body and drive part, with the stator, easy to install. Adopt stator and rotor structure design, ביצועי איטום טובים. The rotor and stator pairs form a self-sealing structure that is Easy to replace. Through the directional rotation of the rotor in the stator cavity, the media conveying function is realized. The conveying process does not have any influence on the properties of the medium. At the same time through the motor reversal, easy to achieve Media suction function, ensure the media and materials clean, ללא דליפה, אין זיהום!

Triaxial dispensers:

The main function to achieve three-axis movement

1.Functions of drawing points, קווים, surfaces, circle, consecutive interpolation of irregular curves and three axis linkage enables to pot any irregular workpieces;

2.software can use achieve three-axis movement that has functions of regional array,translation,rotation and computation,וכו;

3.The size of glue, speed of glue spread, מחלק זמן, time of halting dispensing can be set parameters. With this method, glue outflow is quite stable without leaking and dripping;

4.Fully automatic operation with integration of metering,שתילה,encapsulation function.

5.Mixing on demand and potting at the same time to save glue.

6.Dual barrels to store A,B glue separately, which prevents gel in a long time.

7.Optional dynamic or static mixing mode ensure full mixing, and mixing ratio can be regulated from 100:100 ל 100:10.

8.Especial control system without impaction from air pressure,which avoids the phenomenon of nonuniformity, drawing and bubble in the potting process.

9.Height-adjusting device of Z-axis enables to work for workpieces of which the height are different; 12.Automatic alarming by up /low level materials sensors to avoid short of material.

10.Optional functions of stirring, heating and deaeration,fit for various potting /dispensing process.