פורסם ב השאר תגובה

רכיב אלקטרוני שלוש רעידות דבקות אנטי, בידוד, אנטי-הדבקה

רכיב אלקטרוני שלוש רעידות דבקות אנטי, בידוד, אנטי-הדבקה

After the SMT soldering process, in order to make the components anti-vibration, בידוד, anti-glare, especially for coil components, it must be fixed and sealed. It is also necessary to use an adhesive that acts as a positioning seal. The positioning sealant should have the following characteristics:

1, the appropriate viscosity, easy to sizing operation.
2, חסין לחות, anti-vibration, good insulation performance.
3, the surface drying time should not be too short, usually about 30min is appropriate, in order to facilitate the adjustment of components such as coils during this period.
4, according to the needs of the product, sometimes need to use a fully cured adhesive, and sometimes need to use a self-adhesive type to facilitate the replacement and repair of components.

Electronic component three anti adhesive is various synthetic rubbers and polyesters that can be used as adhesives for positioning sealants. These rubbers have high cold resistance, air tightness and electrical insulation, and high bond strength and elongation. These glues are used for positioning and sealing. The glue should be formulated into a solvent-based adhesive when used. When the viscosity changes, it can be diluted with a solvent at any time. When applying glue, hand-coating is carried out using a pneumatic injection device and a watering can, a brush or a brush.
למרות זאת, because such glues contain solvents, which are harmful to the atmosphere and the human body, there is a tendency to be replaced by RTV organic silica gel. As a positioning seal, a one-component room temperature vulcanized silicone rubber is used, which has good electrical insulation. דבק, plastic cylinder packaging, can be directly sized.

השאר תגובה