Pneumatisk:the material cylinder and the cylinder are connected to the main body of the dispensing valve is made up of three parts: cylinder, valve body and material cylinder. The air cylinder and valve body are separated by advanced sealing material to prevent glue from invading the cylinder. The pneumatic body is used for the movement of the solenoid valve to drive the center rod up and down, and the up and down movement of the center rod is used to open and close the glue According to the different ways of opening and closing, it can be divided into: plunger-type valve, ejector-type valve, lifting-type valve, spray-dispensing valve, and jet-dispensing valve is the highest accuracy; the switching mode is Different, and the applicable fluid is also On the other hand, the suction-suction valve adopts an upward movement and closes the glue structure,so that the glue is sucked and broken at the same time and the residual glue on the remaining needle is reduced, so that the dispensing does not produce the phenomenon of leaking or drawing. Ventilkroppen är anodiserad av aluminiumlegering. The sealing material adopts The latest PTFE material. The contact colloid part is corrosion-resistant material.

Electric: mainly divided into a gear pump and a peristaltic pump including the pump body and drive part, with the stator, easy to install. Adopt stator and rotor structure design, god tätning prestanda. The rotor and stator pairs form a self-sealing structure that is Easy to replace. Through the directional rotation of the rotor in the stator cavity, the media conveying function is realized. Transportprocessen har ingen inverkan på mediets egenskaper. Samtidigt genom motoromkastningen, lätt att uppnå Media sugfunktion, se till att media och material är rena, inget läckage, ingen förorening!

Triaxiala dispensrar:

Huvudfunktionen för att uppnå treaxlig rörelse

1.Ritpunkters funktioner, rader, ytor, cirkel, konsekutiv interpolering av oregelbundna kurvor och treaxlig länkning gör det möjligt att ingjuta alla oregelbundna arbetsstycken;

2.programvara kan använda uppnå tre-axlig rörelse som har funktioner för regional array,översättning,rotation och beräkning,etc;

3.Storleken på lim, limspridningshastigheten, doseringstiden, tid för att stoppa utmatningen kan ställas in parametrar. Med denna metod, limutflödet är ganska stabilt utan att läcka och droppa;

4.Helautomatisk drift med integration av mätning,potting,inkapslingsfunktion.

5.Mixing on demand and potting at the same time to save glue.

6.Dual barrels to store A,B glue separately, which prevents gel in a long time.

7.Optional dynamic or static mixing mode ensure full mixing, and mixing ratio can be regulated from 100:100 till 100:10.

8.Especial control system without impaction from air pressure,which avoids the phenomenon of nonuniformity, drawing and bubble in the potting process.

9.Height-adjusting device of Z-axis enables to work for workpieces of which the height are different; 12.Automatic alarming by up /low level materials sensors to avoid short of material.

10.Optional functions of stirring, heating and deaeration,fit for various potting /dispensing process.